SPS TestManager

Changelog for SPS TestManager v2.13.5 from 02.11.2022

Central/overall

• Device initialisation settings multiphase support implemented for ACS, APS, DCS and LVA
• TDG Webinterface button enabled
• Window size save/load optimised
• Device instrument coupling collision check revised

EMC

• DNV-CG-0339
  • Test 4 DC: Startramp and endramp were added to the test
  • Test 5: U_end value of DC test corrected
  • Test 14.4 AC test: Infinity loop fixed
  • Test 14.4 DC test: Mistake in writing corrected
• DNVGL-CG-0339
  • Test 4 DC: Startramp and endramp were added to the test
  • Test 5: U_end value of DC test corrected
  • Test 14.4 AC test: Infinity loop fixed
  • Test 14.4 DC test: Mistake in writing corrected
• IEC 60146-1-1
  • Total harmonic distortion THD: Up to now, the individual harmonics were added to the fundamental voltage, resulting into a slightly increased rms value. Now, the rms value of the fundamental waveform remains at the nominal voltage
  • Commutation notches: New parameter limits for 'depth'
  • Voltage amplitude tolerance: U_max and U_min are now calculated correctly if global U_n changes
• IEC 61000-2-2
  • 4.3 Harmonics: Parameter 'THD' had a wrong default value
• IEC 61000-4-11
  • Digital output settings in graphic enabled
• IEC 61000-4-34
  • Graphic was reworked
• IEC 61131-2
  • Voltage interruptions: New min. limit for parameter t_interval
• IEC 61496-1
  • 5.4.1 Rated supply voltage - AC supply - Frequency: new min. / max. limits for parameters 'Factor for f_n,high' and 'Factor for f_n,low'
  • 5.4.1 Rated supply voltage - AC supply - Harmonics: Up to now, the individual harmonics were added to the fundamental voltage, resulting into a slightly increased rms value. Now, the rms value of the fundamental waveform remains at the nominal voltage
  • 5.4.3.2 Supply voltage interruptions: Test status of t_0 step has had a wrong time
• IEC 61800-3
  • Individual harmonic orders: Some harmonics run now with a start angle of 180°; Graphic was reworked; Up to now, the individual harmonics were added to the fundamental voltage, resulting into a slightly increased rms value. Now, the fundamental voltage is adjusted in a way, that the rms value of the resulting waveform remains at the nominal voltage
  • Commutation notches: New limits for parameter 'depth'; Parameter 'attenuation in degree' is deleated; Parameter 'total area' will now be recalculated if other parameter changes
  • Voltage deviation: Graphic was reworked; U_max and U_min are now calculated correctly if global U_n changes
  • Voltage unbalance: Graphic was reworked; Parameter 'ku2' is renamed in 'τ (voltage unbalance)'
  • Frequency variation: Test sequence was changed
  • Voltage dips: Gaphic was reworked; Voltage values were now calcutated correctly
  • Voltage dips and short interruptions: Test sequence stops now on the device if the test is cancelled
  • Total harmonic distortion: Parameter 'THD' has had a wrong default value
• IEC 62040-2
  • All test sequences and graphics were reworked